Misplaced Pages

#514485

31-615: The Bald Eagle is defined as a gray to olive-gray and grayish-red, fine to coarse-grained crossbedded sandstone or greywacke . A conglomeratic member, called the Lost Run Member, exists in some locations. The depositional environment of the Bald Eagle has always been interpreted as mostly terrestrial or shallow marine deposits resulting in a molasse sequence produced by the Taconic orogeny . Very few fossils exist in

62-628: A fluid flows over a bed with mobile material. It is most common in stream deposits (consisting of sand and gravel), tidal areas, and in aeolian dunes. Cross-bedded sediments are recognized in the field by the many layers of " foresets ", which are the series of layers that form on the downstream or lee side of the bedform (ripple or dune). These foresets are individually differentiable because of small-scale separation between layers of material of different sizes and densities. Cross-bedding can also be recognized by truncations in sets of ripple foresets, where previously-existing stream deposits are eroded by

93-475: A later flood, and new bedforms are deposited in the scoured area. Cross-bedding can be subdivided according to the geometry of the sets and cross-strata into subcategories. The most commonly described types are tabular cross-bedding and trough cross-bedding. Tabular cross-bedding, or planar bedding consists of cross-bedded units that are extensive horizontally relative to the set thickness and that have essentially planar bounding surfaces. Trough cross-bedding, on

124-431: A set of cross-beds. However, to get a true reading, the axis of the beds must be visible. It is also difficult to distinguish between the cross-beds of a dune and the cross-beds of an antidune . (Dunes dip downstream while antidunes dip upstream.) The direction of motion of the cross-beds can show ancient flow or wind directions (called paleocurrents). The foresets are deposited at the angle of repose (~34 degrees from

155-595: A variety of time scales can change water depth, and speed. Some rivers can be characterized by a predictable seasonably controlled hydrograph (reflecting snow melt or rainy season). Others are dominated by durational variations characteristic of alpine glaciers run-off or random storm events, which produce flashy discharge. Few rivers have a long term record of steady flow in the rock record. Bed forms are relatively dynamic sediment storage bodies with response times that are short relative to major changes in flow characteristics. Large scale bed forms are periodic and occur in

186-546: Is a specific type of particle transport by fluids such as wind or water . It occurs when loose materials are removed from a bed and carried by the fluid, before being transported back to the surface. Examples include pebble transport by rivers, sand drift over desert surfaces, soil blowing over fields, and snow drift over smooth surfaces such as those in the Arctic or Canadian Prairies . At low fluid velocities, loose material rolls downstream, staying in contact with

217-410: Is formed mainly by migration of large-scale, straight-crested ripples and dunes. It forms during lower-flow regimes. Individual beds range in thickness from a few tens of centimeters to a meter or more, but bed thickness down to 10 centimeters has been observed. Where the set height is less than 6 centimeters and the cross-stratification layers are only a few millimeters thick, the term cross-lamination

248-462: Is generally sorted before and during deposition on the "lee" side of the dune, allowing cross-strata to be recognized in rocks and sediment deposits. The angle and direction of cross-beds are generally fairly consistent. Individual cross-beds can range in thickness from just a few tens of centimeters, up to hundreds of feet or more depending upon the depositional environment and the size of the bedform. Cross-bedding can form in any environment in which

279-423: Is layering within a stratum and at an angle to the main bedding plane. The sedimentary structures which result are roughly horizontal units composed of inclined layers. The original depositional layering is tilted, such tilting not being the result of post-depositional deformation . Cross-beds or "sets" are the groups of inclined layers, which are known as cross-strata. Cross-bedding forms during deposition on

310-457: Is used, rather than cross-bedding. Cross-bed sets occur typically in granular sediments, especially sandstone , and indicate that sediments were deposited as ripples or dunes, which advanced due to a water or air current. Cross-beds are layers of sediment that are inclined relative to the base and top of the bed they are associated with. Cross-beds can tell modern geologists many things about ancient environments such as- depositional environment,

341-535: The Juniata Formation . The Bald Eagle is a good source of road material, riprap and building stone. However, iron pyrite inclusions may lead to acidic rainwater runoff. This article about a specific stratigraphic formation in Pennsylvania is a stub . You can help Misplaced Pages by expanding it . Crossbedding In geology , cross-bedding , also known as cross-stratification ,

SECTION 10

#1732787548515

372-707: The Bald Eagle Formation, and most of them are trace fossils . However, at the base of the formation is the Orthorynchula biostratigraphic marker bed, which contains abundant Orthorynchula brachiopods . Relative age dating of the Bald Eagle places it in the Upper Ordovician period, being deposited between 488.3 and 443.7 (±10) million years ago. It rests conformably atop the Reedsville Formation and conformably below

403-458: The bedform and collect at the peak until the angle of repose is reached. At this point, the crest of granular material has grown too large and will be overcome by the force of the moving water, falling down the lee(downstream) side of the dune. Repeated avalanches will eventually form the sedimentary structure known as cross-bedding, with the structure dipping in the direction of the paleocurrent. The sediment that goes on to form cross-stratification

434-476: The channel (scaled to depth). Their presence and morphologic variability have been related to flow strength expressed as mean velocity or shear stress . In a fluvial environment, the water in a stream loses energy and its ability transport sediment. The sediment "falls" out of the water and is deposited along a point bar. Over time the river may dry up or avulse and the point bar may be preserved as cross-bedding. Tide dominated environments include: In general,

465-406: The direction of sediment transport (paleocurrent) and even environmental conditions at the time of deposition. Typically, units in the rock record are referred to as beds, while the constituent layers that make up the bed are referred to as laminae, when they are less than 1 cm thick and strata when they are greater than 1 cm in thickness. Cross-beds are angled relative to either the base or

496-505: The dust in dust storms. In rivers, this process repeats continually, gradually eroding away the river bed, but also transporting-in fresh material from upstream. The speed at which the flow can move particles by saltation is given by the Bagnold formula . Suspension generally affects small particles ('small' means ~70 micrometres or less for particles in air). For these particles, vertical drag forces due to turbulent fluctuations in

527-591: The estuary are flood dominated and other parts are ebb dominated. The temporal and spatial variability of flow and sediment transport, coupled with regular fluctuating water levels creates a variety of bed form morphology. Large scale bed forms occur on shallow, terrigenous or carbonate clastic continental shelves and epicontinental platforms which are affected by strong geostrophic currents , occasional storm surges and/or tide currents. In an aeolian environment, cross-beds often exhibit inverse grading due to their deposition by grain flows . Winds blow sediment along

558-402: The fence. A 2008 study found that saltating sand particles induces a static electric field by friction. Saltating sand acquires a negative charge relative to the ground which in turn loosens more sand particles which then begin saltating. This process has been found to double the number of particles predicted by previous theory. This is significant in meteorology because it is primarily

589-417: The fluid are similar in magnitude to the weight of the particle. These smaller particles are carried by the fluid in suspension, and advected downstream. The smaller the particle, the less important the downward pull of gravity, and the longer the particle is likely to stay in suspension. A fence designed with holes can mitigate saltation by reducing particle speed, and sand accumulates on the leeward side of

620-455: The fluid, and pulled downward by gravity, causing them to travel in roughly ballistic trajectories. If a particle has obtained sufficient speed from the acceleration by the fluid, it can eject, or splash , other particles in saltation, which propagates the process. Depending on the surface, the particle could also disintegrate on impact, or eject much finer sediment from the surface. In air, this process of saltation bombardment creates most of

651-424: The grains and the sorting and composition of sediment can provide additional information on the history of cross-beds. Roundness of the grains, limited variation in grain size, and high quartz contents are generally attributed to longer histories of weathering and sediment transport. For example: well-rounded, and well-sorted sand that is mostly composed of quartz grains is commonly found in beach environments, far from

SECTION 20

#1732787548515

682-462: The greater the tidal range the greater the maximum flow strength. Cross-stratification in tidal-dominated areas can lead to the formation of Herringbone cross-stratification . Although the flow direction reverses regularly, the flow patterns of flood on ebb currents commonly do not coincide. Consequently, the water and transport sediment may follow a roundabout route in and out of the estuary. This leads to spatially varied systems where some parts of

713-573: The ground until they start to accumulate. The side that the accumulation occurs on is called the windward side. As it continues to build, some sediment falls over the end. This side is called the leeward side . Grain flows occur when the windward side accumulates too much sediment, the angle of repose is reached and the sediment tumbles down. As more sediment piles on top the weight causes the underlying sediment to cement together and form cross-beds. Saltation (geology) In geology , saltation (from Latin saltus  'leap, jump')

744-403: The horizontal), so geologists are able to measure dip direction of the cross-bedded sediments and calculate the paleoflow direction. However, most cross-beds are not tabular, they are troughs . Since troughs can give a 180 degree variation of the dip of foresets, false paleocurrents can be taken by blindly measuring foresets. In this case, true paleocurrent direction is determined by the axis of

775-529: The inclined surfaces of bedforms such as ripples and dunes ; it indicates that the depositional environment contained a flowing medium (typically water or wind). Examples of these bedforms are ripples, dunes, anti-dunes, sand waves , hummocks , bars , and delta slopes. Environments in which water movement is fast enough and deep enough to develop large-scale bed forms fall into three natural groupings: rivers, tide-dominated coastal and marine settings. Cross-beds can tell geologists much about what an area

806-431: The other hand, consists of cross-bedded units in which the bounding surfaces are curved, and hence limited in horizontal extent. Tabular (planar) cross-beds consist of cross-bedded units that are large in horizontal extent relative to set thickness and that have essentially planar bounding surfaces. The foreset laminae of tabular cross-beds are curved so as to become tangential to the basal surface. Tabular cross-bedding

837-478: The source of the sediment. Poorly sorted and angular sediment that is composed of a diversity of minerals is more commonly found in rivers, near the source of the sediment. However, older sedimentary deposits are frequently eroded and re-mobilized. Thus, a river may well erode an older formation of well-rounded, well-sorted beach sands of nearly pure quartz. Flows are characterized by climate (snows, rain, and ice melting) and gradient. Discharge variations measured on

868-423: The surface. This is called creep or reptation . Here the forces exerted by the fluid on the particle are only enough to roll the particle around the point of contact with the surface. Once the wind speed reaches a certain critical value, termed the impact or fluid threshold , the drag and lift forces exerted by the fluid are sufficient to lift some particles from the surface. These particles are accelerated by

899-402: The top of the surrounding beds. As opposed to angled beds, cross-beds are deposited at an angle rather than deposited horizontally and deformed later on. Trough cross-beds have lower surfaces which are curved or scoop shaped and truncate the underlying beds. The foreset beds are also curved and merge tangentially with the lower surface. They are associated with sand dune migration. The shape of

930-403: The trough. Paleocurrent direction is important in reconstructing past climate and drainage patterns: sand dunes preserve the prevalent wind directions, and current ripples show the direction rivers were moving. Cross-bedding is formed by the downstream migration of bedforms such as ripples or dunes in a flowing fluid. The fluid flow causes sand grains to saltate up the stoss (upstream) side of

961-401: Was like in ancient times. The direction the beds are dipping indicates paleocurrent , the rough direction of sediment transport. The type and condition of sediments can tell geologists the type of environment (rounding, sorting, composition...). Studying modern analogs allows geologists to draw conclusions about ancient environments. Paleocurrent can be determined by seeing a cross-section of

Bald Eagle Formation - Misplaced Pages Continue

#514485