Misplaced Pages

State Implementation Plan

Article snapshot taken from Wikipedia with creative commons attribution-sharealike license. Give it a read and then ask your questions in the chat. We can research this topic together.

A State Implementation Plan ( SIP ) is a United States state plan for complying with the federal Clean Air Act , administered by the Environmental Protection Agency (EPA). The SIP, developed by a state agency and approved by EPA, consists of narrative, rules, technical documentation, and agreements that an individual state will use to control and clean up polluted areas.

#543456

6-531: The Lowest achievable emissions rate ( LAER ) is used by the EPA to determine if emissions from a new or modified major stationary source are acceptable under SIP guidelines. LAER standards are required when a new stationary source is located in a non-attainment air-quality region . It is the most stringent air pollution standard above the best available control technology and reasonably available control technology standards. Best available control technology ( BACT )

12-456: A reduction in the measured sulfur dioxide (SO 2 ) emitted by coal-fired power plants . The State Implementation Plan to decrease the SO 2 emitted by such plants was to increase the height of the smokestacks on the plants. The result was that the SO 2 was carried in the wind out of the state and there was a reduction in the measured SO 2 in the area near the source. In the 1977 amendments to

18-571: A specific pollutant to a specified limit. RACT applies to existing sources in areas that are not meeting national ambient air quality standards on controlled air pollutants and is required on all sources that meet these criteria. The RACT standard is less stringent than either the BACT or the LAER standard set forth by the EPA. In Ohio , between 1970 and 1977, a rule in the Clean Air Act required

24-498: Is a pollution control standard mandated by the Clean Air Act: The EPA determines what air pollution control technology will be used to control a specific pollutant to a specified limit. When a BACT is determined, factors such as energy consumption, total source emission, regional environmental impact, and economic costs are taken into account. It is the current EPA standard for all polluting sources that fall under

30-522: The New Source Review guidelines and is determined on a case-by-case basis. The BACT standard is significantly more stringent than the reasonably available control technology standard but much less stringent than the lowest achievable emissions rate standard. Reasonably available control technology ( RACT ) is a pollution control standard created by the EPA and is used to determine what air pollution control technology will be used to control

36-571: The Act, Congress restricted the use of tall smokestacks as a means to attain compliance in SIPs. Major stationary source A major stationary source is a source that emits more than a certain amount of a pollutant as defined by the U.S. Environmental Protection Agency (EPA). The amount of pollutants allowed for certain new sources is defined by the EPA's New Source Performance Standards (NSPRS). A stationary source in air quality terminology

#543456