Misplaced Pages

Panzerabwehrkanone

Article snapshot taken from Wikipedia with creative commons attribution-sharealike license. Give it a read and then ask your questions in the chat. We can research this topic together.

An anti-tank gun is a form of artillery designed to destroy tanks and other armoured fighting vehicles , normally from a static defensive position. The development of specialized anti-tank munitions and anti-tank guns was prompted by the appearance of tanks during World War I . To destroy hostile tanks, artillerymen often used field guns depressed to fire directly at their targets, but this practice expended too much valuable ammunition and was of increasingly limited effectiveness as tank armor became thicker. The first dedicated anti-tank artillery began appearing in the 1920s, and by World War II was a common appearance in many European armies. To penetrate armor, they fired specialized ammunition from longer barrels to achieve a higher muzzle velocity than field guns. Most anti-tank guns were developed in the 1930s as improvements in tanks were noted, and nearly every major arms manufacturer produced one type or another.

#723276

31-520: Panzerabwehrkanone , usually referred to as Pak , is the German term for anti-tank gun . Before and during World War II , the German Army produced a series of 13 anti-tank guns which they designated Panzerabwehrkanone, i.e. Pak. In addition, they produced a weapon designated an anti-tank rifle, which is generally considered to be an anti-tank gun; another gun they designated Panzerabwehrwerfer (PAW)

62-652: A Panzer I chassis . and were used in the Battle of France The trend continued with older tanks and captured vehicles, which were available in large numbers for conversions to self-propelled guns when they were replaced by heavier and better-armed (and armored) tanks. Although just a makeshift solution, these initial experiments proved so successful, they spawned an entire class of new vehicles: dedicated tank destroyers . The US Army's early self-propelled anti-tank guns were 75 mm on M2 half-tracks (entering service in 1941) to complement towed artillery and M6 gun motor carriage

93-407: A 37 mm on 4-wheel-drive Dodge truck (1942). US tank destroyer doctrine emphasised mobility to place the tank destroyers into positions to ambush tank attacks. Tank destroyers offered some advantages over towed anti-tank guns, since a static gun emplacement sacrificed concealment and surprise after firing the first shot, but the same gun mounted on a tracked or wheeled chassis could open fire and throw

124-553: A heavier weapon. All of these guns were meant to be towed. The earlier ones were light weight enough to be moved by hand, over short distances, into, and out of, their firing positions. Some variants were only used on tank destroyers, which are self-propelled, like the cannons on tanks. After each gun, the year of introduction is given. Anti-tank gun Anti-tank guns deployed during World War II were often manned by specialist infantry rather than artillery crews, and issued to light infantry units accordingly. The anti-tank guns of

155-540: A high muzzle velocity and could be fired from low-recoil, man-portable light weapons, such as the Panzerfaust and the American series of recoilless rifles . Although several large-caliber guns were developed during the war that were capable of knocking out the most heavily armored tanks, they proved expensive and difficult to conceal. The later generation of low-recoil anti-tank weapons, which allowed projectiles

186-633: A number of countries began producing man-portable anti-tank weapons using this ammunition. The development of man-portable, shoulder-fired, anti-tank rocket launchers began in 1941; most could be reloaded, but a few, such as the German Panzerfaust , were fired from disposable tubes. Unlike anti-tank guns, their light weight made them easily portable by individual infantrymen on the battlefield, and they offered similar degrees of firepower whilst being quicker and cheaper to produce. Towed anti-tank guns disappeared from most Western countries, such as

217-610: A postwar 90-mm anti-tank gun of its own, the Pak 50/57 , firing shells with an even lower velocity than the Mecar or DEFA guns. Apart from the T-12, which used APDS rounds, these weapons could only use HEAT shells for armor-piercing purposes. France did introduce an APFSDS shell for the DEFA D921 at some point in the 1980s. The last country known to have produced a dedicated anti-tank gun was

248-479: A split rail mounting. They were able to destroy tanks fielded by both sides during the first two years of the war, but soon proved impotent against the heavier tank armor that debuted in 1940. French doctrine was for their infantry to let enemy tanks pass through then stop the accompanying enemy infantry leaving the unsupported tanks to be engaged by anti-tank guns deployed in three echelons. The issue of 58 guns per division provided 10 guns per kilometre of front which

279-422: A tank formation into substantial disarray before quickly withdrawing to repeat the same tactic elsewhere. The introduction of tank destroyers also put an end to the traditional tactic of suppressing anti-tank gun batteries with heavy artillery bombardments, as their crews were now well-protected under armor. They were not without their own series of disadvantages, however, namely presenting a much larger target than

310-583: A tank rather than merely penetrating its armor plate. Towed guns similar to the Pak 36 were the only anti-tank weapon issued to European armies during the 1930s, and a number of influential designs proliferated, such as the Böhler gun . By the late 1930s, anti-tank guns had been manufactured by companies in Germany, Austria, France, Czechoslovakia , Belgium, Great Britain, Denmark, and Sweden. A few countries, such as

341-507: A tank's armor at long range, but without explosive firepower, often failed to cause catastrophic damage, kill, or even seriously injure the crew, or disable the tank. A number of infantry support guns designed to defeat hard targets such as fortified machine gun emplacements were used as makeshift anti-tank weapons, including the French Canon d'Infanterie de 37 modèle 1916 TRP . The 3.7 cm Tankabwehrkanone 1918 im starrer Räder–lafette

SECTION 10

#1732780611724

372-514: A towed gun, the added responsibilities of vehicle maintenance and logistical support, and the limited spaces in which the crew had to operate and stow all their available ammunition. By the end of the war, dedicated tank destroyers had been superseded by tanks, which were just as effective at destroying other tanks, and little incentive remained to continue their separate development. Nevertheless, much like towed anti-tank guns, they were widely exported and are still in service with some militaries in

403-588: The Wehrmacht fielded the even larger 7.5 cm Pak 41 and 8.8 cm Pak 43 . While the early 37-mm anti-tank guns were easily concealed and moved, the large-caliber weapons available late in the war required equally large vehicles to tow them into place, and were difficult to conceal, dig in, withdraw, or reposition. By 1945, large anti-tank guns had become almost impractical in their role, and their size and weight were considered liabilities. They were also expensive to produce and although they were capable of defeating

434-525: The article wizard to submit a draft for review, or request a new article . Search for " Cannone da 47 " in existing articles. Look for pages within Misplaced Pages that link to this title . Other reasons this message may be displayed: If a page was recently created here, it may not be visible yet because of a delay in updating the database; wait a few minutes or try the purge function . Titles on Misplaced Pages are case sensitive except for

465-561: The 1920s and 1930s were of small caliber; nearly all major armies possessing them used 37 mm ammunition (the British Army used the slightly larger 40 mm 2-pounder gun ). As World War II progressed, the appearance of heavier tanks rendered these weapons obsolete, and anti-tank guns likewise began firing larger and more effective armor-piercing shot. The development of the compact hollow charge projectile permanently altered anti-tank warfare, since this type of ammunition did not depend on

496-448: The 1980s and 1990s. The first specialized anti-tank weaponry consisted of anti-tank rifles . These emerged from the mixed results of deploying field artillery against tanks during World War I, and the need to produce a more economical weapon to destroy them. Most anti-tank rifles were over 1.3 m (4 ft 3 in) in length, however, and difficult for infantrymen to operate in the confines of their trenches. They could penetrate

527-472: The 40- to 50-mm range began to appear, some of which simply used rebored 37-mm barrels. Although they, too, were soon approaching obsolescence, most remained in use with infantry units until the end of the war. Anti-tank guns remained ineffective against sloped armor , as demonstrated by an incident in 1941 when a single Soviet T-34 tank was hit more than 30 times by a battalion-sized contingent of German 37 and 50-mm anti-tank guns. The tank survived intact and

558-952: The People's Republic of China in 1988. The Chinese gun was known as the Norinco Type 86 and was probably manufactured as a replacement for the aging Soviet-sourced T-12. Anti-tank guns continued to be used in a number of conflicts around the world, such as the Six-Day War and the South African Border War . Soviet anti-tank guns in particular were exported to at least 18 other countries after being retired from service, and have continued to see action. Although still being drawn by horses or towed by trucks, towed anti-tank guns were initially much lighter and more portable than field guns, making them well-suited to infantry maneuvers. As their size and caliber increased, though,

589-691: The Soviet Union, also manufactured foreign designs under license. At the outbreak of World War II, most armies were fielding light anti-tank guns firing 3.7-cm (37-mm) ammunition. The guns were usually mounted on two-wheeled carriages so they could be towed into position, then withdrawn and repositioned rapidly. Since they weighed only a few hundred pounds on average, they could also be manhandled into position. All fired high-explosive and solid armor-piercing shot effective at ranges up to roughly 500 m (1,600 ft), and an increasing number were manufactured with protective gun shields in addition to

620-477: The United States, after World War II, to be replaced by shoulder-fired rocket launchers, recoilless rifles, and eventually, guided anti-tank missiles. At the end of the war, German engineers had proposed a new, large-caliber anti-tank gun that used less propellant than a rocket or recoilless weapon, yet fired similar compact hollow-charge shells. German forces subsequently fielded the 8 cm PAW 600 , which

651-416: The anti-tank launcher. These weapons ranged from a weight of 229 kg (500 lb) to a weight of 10,160 kg (20,000 lb). The smallest caliber was 28 mm (1 in) and the largest was 128 mm (5 in). Over the six-year course of World War II the armor of the tanks steadily improved, so in order to be effective the size of the projectile had to increase. A larger projectile required

SECTION 20

#1732780611724

682-615: The end of World War II, armor plating became still thicker, with tanks such as the Tiger II being fitted with armor over 100 mm (3.9 in) in thickness, as compared to 15 mm (0.59 in) which was more typical in 1939. This prompted the development of a third generation of anti-tank guns, large-caliber pieces in the 57- to 100-mm range. The British Army adopted the Ordnance QF 6-pounder and Ordnance QF 17-pounder , which were then considered great advances in firepower, and

713-482: The guns likewise became increasingly heavy and cumbersome, restricting their role to static defense. In consequence, during World War II, both sides were compelled to make anti-tank guns self-propelled, which greatly increased their mobility. The first self-propelled anti-tank guns were merely belated attempts to make use of obsolete tanks, such as the Panzerjäger I , which was a Czech 4.7-cm Pak (t) gun mated to

744-983: The late 20th and early 21st century. Cannone da 47 Look for Cannone da 47 on one of Misplaced Pages's sister projects : [REDACTED] Wiktionary (dictionary) [REDACTED] Wikibooks (textbooks) [REDACTED] Wikiquote (quotations) [REDACTED] Wikisource (library) [REDACTED] Wikiversity (learning resources) [REDACTED] Commons (media) [REDACTED] Wikivoyage (travel guide) [REDACTED] Wikinews (news source) [REDACTED] Wikidata (linked database) [REDACTED] Wikispecies (species directory) Misplaced Pages does not have an article with this exact name. Please search for Cannone da 47 in Misplaced Pages to check for alternative titles or spellings. You need to log in or create an account and be autoconfirmed to create new articles. Alternatively, you can use

775-455: The lightly rifled French DEFA D921 anti-tank gun, which fired fin-stabilized shells and was available on a towed carriage or as a vehicle mount. It was later mated to the AML-90 and EBR series of French armored cars. The Soviet Union also adopted a similar design around the same time, the 100-mm T-12 anti-tank gun , which was smoothbore and fired fin-stabilized shells. Switzerland developed

806-409: The most formidable of opponents, most tank units still consisted of less heavily armoured models that remained vulnerable to less expensive and more practical guns, as well. Many heavy anti-tank guns were issued, at least initially, on the divisional level, but gradually made their way to individual infantry battalions. Meanwhile, the effect of very compact hollow charge warheads was being noted, and

837-531: The size of an artillery shell to be fired from the shoulder, was considered a far more viable option for arming infantry. Recoilless rifles replaced most conventional anti-tank guns in the postwar period; nevertheless, the development of new anti-tank guns exhibiting similar low-recoil performance continued until the late 1950s in France, Belgium, and the Soviet Union . A few Soviet designs saw combat well into

868-468: Was an extremely lightweight, low-pressure weapon still able to fire the same ammunition types as higher-velocity anti-tank guns. In the 1950s, this idea was revived by a Belgian firm, Mecar , which subsequently improved on the concept and developed a low-pressure, smoothbore, 90-mm anti-tank gun. Because of its low recoil forces and light construction, the gun was particularly useful for being mounted on armored cars or small gun carriages. Its design inspired

899-655: Was driven back to its own lines a few hours later. This helped earn the Pak 36 the moniker of Panzeranklopfgerät ("tank door knocker") because its crew simply revealed their presence and wasted their shells without damaging the T-34's armor. Anti-tank gunners began aiming at tank tracks, or vulnerable margins on the turret ring and gun mantlet , rather than testing their lighter cannon against bow and turret armor. These difficulties resulted in new types of ammunition being issued, namely high-explosive anti-tank (HEAT) and armor-piercing discarding sabot (APDS) projectiles. Towards

930-454: Was expected to be able to deal with enemy tanks at a concentration of 50 tanks per kilometer. In practice the German invasion of France concentrated tanks in select divisions at up to 100 per kilometer. Introducing improved ammunition and increasing muzzle velocity initially helped compensate for their mediocre performance, but small-caliber anti-tank guns clearly would soon be overtaken by yet more heavily armored tanks. Medium-caliber guns in

961-486: Was probably the first dedicated anti-tank gun in service. However, its gun barrel was based on an earlier Hotchkiss 5-barrelled rotary-cannon . The 3.7 cm TAK 1918 was designed and built for the Imperial German Army in 1918. The 3.7 cm Pak 36 which first appeared in 1928 was probably the first purpose-built anti-tank gun. Weighing some 160 kg, the Pak 36 could inflict a catastrophic kill on

Panzerabwehrkanone - Misplaced Pages Continue

#723276