5-488: Quality control is a process for maintaining proper standards in manufacturing. Quality control may also refer to: Quality control Quality control ( QC ) is a process by which entities review the quality of all factors involved in production . ISO 9000 defines quality control as "a part of quality management focused on fulfilling quality requirements". This approach places emphasis on three aspects (enshrined in standards such as ISO 9001): Inspection
10-430: Is a major component of quality control, where physical product is examined visually (or the end results of a service are analyzed). Product inspectors will be provided with lists and descriptions of unacceptable product defects such as cracks or surface blemishes for example. Early stone tools such as anvils had no holes and were not designed as interchangeable parts . Mass production established processes for
15-444: The creation of parts and system with identical dimensions and design, but these processes are not uniform and hence some customers were unsatisfied with the result. Quality control separates the act of testing products to uncover defects from the decision to allow or deny product release, which may be determined by fiscal constraints. For contract work, particularly work awarded by government agencies, quality control issues are among
20-479: The limits. Quality was thus precisely defined using devices such as plug gauges and ring gauges . However, this did not address the problem of defective items; recycling or disposing of the waste adds to the cost of production, as does trying to reduce the defect rate. Various methods have been proposed to prioritize quality control issues and determine whether to leave them unaddressed or use quality assurance techniques to improve and stabilize production. There
25-440: The top reasons for not renewing a contract. The simplest form of quality control was a sketch of the desired item. If the sketch did not match the item, it was rejected, in a simple Go/no go procedure. However, manufacturers soon found it was difficult and costly to make parts be exactly like their depiction; hence around 1840 tolerance limits were introduced, wherein a design would function if its parts were measured to be within
#281718