Misplaced Pages

#937062

21-399: A rift is a geological structure. Rift ( s ) or The Rift may also refer to: Rift Major rifts occur along the central axis of most mid-ocean ridges , where new oceanic crust and lithosphere is created along a divergent boundary between two tectonic plates . Failed rifts are the result of continental rifting that failed to continue to the point of break-up. Typically

42-449: A lacustrine environment or in a restricted marine environment, although not all rifts contain such sequences. Reservoir rocks may be developed in pre-rift, syn-rift and post-rift sequences. Effective regional seals may be present within the post-rift sequence if mudstones or evaporites are deposited. Just over half of estimated oil reserves are found associated with rifts containing marine syn-rift and post-rift sequences, just under

63-403: A kind of orogeneses in extensional settings, which is referred as to rifting orogeny. Once rifting ceases, the mantle beneath the rift cools and this is accompanied by a broad area of post-rift subsidence. The amount of subsidence is directly related to the amount of thinning during the rifting phase calculated as the beta factor (initial crustal thickness divided by final crustal thickness), but

84-438: A mid-oceanic ridge and a set of conjugate margins separated by an oceanic basin. Rifting may be active, and controlled by mantle convection . It may also be passive, and driven by far-field tectonic forces that stretch the lithosphere. Margin architecture develops due to spatial and temporal relationships between extensional deformation phases. Margin segmentation eventually leads to the formation of rift domains with variations of

105-514: A quarter in rifts with a non-marine syn-rift and post-rift, and an eighth in non-marine syn-rift with a marine post-rift. Lithospheric flexure In geology , lithospheric flexure (also called regional isostasy ) is the process by which the lithosphere (rigid, thin outer layer of the Earth) bends under the action of forces such as the weight of a growing orogeny or changes in ice thickness related to glaciation . The lithosphere rests on

126-474: A single basin-bounding fault. Segment lengths vary between rifts, depending on the elastic thickness of the lithosphere. Areas of thick colder lithosphere, such as the Baikal Rift have segment lengths in excess of 80 km, while in areas of warmer thin lithosphere, segment lengths may be less than 30 km. Along the axis of the rift the position, and in some cases the polarity (the dip direction), of

147-402: Is also affected by the degree to which the rift basin is filled at each stage, due to the greater density of sediments in contrast to water. The simple 'McKenzie model' of rifting, which considers the rifting stage to be instantaneous, provides a good first order estimate of the amount of crustal thinning from observations of the amount of post-rift subsidence. This has generally been replaced by

168-473: The Moho topography, including proximal domain with fault-rotated crustal blocks, necking zone with thinning of crustal basement , distal domain with deep sag basins, ocean-continent transition and oceanic domain. Deformation and magmatism interact during rift evolution. Magma-rich and magma-poor rifted margins may be formed. Magma-rich margins include major volcanic features. Globally, volcanic margins represent

189-471: The asthenosphere , a viscous layer that in geological time scales behaves like a fluid . Thus, when loaded, the lithosphere progressively reaches an isostatic equilibrium , which represents Archimedes' principle applied to geological settings. This phenomenon was first described in the late 19th century to explain the shorelines uplifted in Scandinavia by the removal of large ice massed during

210-444: The last glaciation . American geologist G. K. Gilbert used it to explain the uplifted shorelines of Lake Bonneville . The concept was not retaken until the 1950s by Vening Meinesz . The geometry of the lithospheric bending is often modeled adopting a pure elastic thin plate approach (sometimes by fitting the gravity anomaly produced by that bending rather than more direct data of it). The thickness of such plate that best fits

231-659: The 'flexural cantilever model', which takes into account the geometry of the rift faults and the flexural isostasy of the upper part of the crust. Some rifts show a complex and prolonged history of rifting, with several distinct phases. The North Sea rift shows evidence of several separate rift phases from the Permian through to the Earliest Cretaceous , a period of over 100 million years. Rifting may lead to continental breakup and formation of oceanic basins. Successful rifting leads to seafloor spreading along

SECTION 10

#1732786669938

252-469: The development of isolated basins. In subaerial rifts, for example, drainage at the onset of rifting is generally internal, with no element of through drainage. As the rift evolves, some of the individual fault segments grow, eventually becoming linked together to form the larger bounding faults. Subsequent extension becomes concentrated on these faults. The longer faults and wider fault spacing leads to more continuous areas of fault-related subsidence along

273-425: The main rift bounding fault changes from segment to segment. Segment boundaries often have a more complex structure and generally cross the rift axis at a high angle. These segment boundary zones accommodate the differences in fault displacement between the segments and are therefore known as accommodation zones. Accommodation zones take various forms, from a simple relay ramp at the overlap between two major faults of

294-567: The majority of passive continental margins. Magma-starved rifted margins are affected by large-scale faulting and crustal hyperextension. As a consequence, upper mantle peridotites and gabbros are commonly exposed and serpentinized along extensional detachments at the seafloor. Many rifts are the sites of at least minor magmatic activity , particularly in the early stages of rifting. Alkali basalts and bimodal volcanism are common products of rift-related magmatism. Recent studies indicate that post-collisional granites in collisional orogens are

315-404: The product of rifting magmatism at converged plate margins. The sedimentary rocks associated with continental rifts host important deposits of both minerals and hydrocarbons . SedEx mineral deposits are found mainly in continental rift settings. They form within post-rift sequences when hydrothermal fluids associated with magmatic activity are expelled at the seabed. Continental rifts are

336-484: The rift axis. Significant uplift of the rift shoulders develops at this stage, strongly influencing drainage and sedimentation in the rift basins. During the climax of lithospheric rifting, as the crust is thinned, the Earth's surface subsides and the Moho becomes correspondingly raised. At the same time, the mantle lithosphere becomes thinned, causing a rise of the top of the asthenosphere. This brings high heat flow from

357-654: The same polarity, to zones of high structural complexity, particularly where the segments have opposite polarity. Accommodation zones may be located where older crustal structures intersect the rift axis. In the Gulf of Suez rift, the Zaafarana accommodation zone is located where a shear zone in the Arabian-Nubian Shield meets the rift. Rift flanks or shoulders are elevated areas around rifts. Rift shoulders are typically about 70 km wide. Contrary to what

378-521: The sites of significant oil and gas accumulations, such as the Viking Graben and the Gulf of Suez Rift . Thirty percent of giant oil and gas fields are found within such a setting. In 1999 it was estimated that there were 200 billion barrels of recoverable oil reserves hosted in rifts. Source rocks are often developed within the sediments filling the active rift ( syn-rift ), forming either in

399-437: The transition from rifting to spreading develops at a triple junction where three converging rifts meet over a hotspot . Two of these evolve to the point of seafloor spreading, while the third ultimately fails, becoming an aulacogen . Most rifts consist of a series of separate segments that together form the linear zone characteristic of rifts. The individual rift segments have a dominantly half-graben geometry, controlled by

420-491: The upwelling asthenosphere into the thinning lithosphere, heating the orogenic lithosphere for dehydration melting, typically causing extreme metamorphism at high thermal gradients of greater than 30 °C. The metamorphic products are high to ultrahigh temperature granulites and their associated migmatite and granites in collisional orogens, with possible emplacement of metamorphic core complexes in continental rift zones but oceanic core complexes in spreading ridges. This leads to

441-549: Was previously thought, elevated passive continental margins (EPCM) such as the Brazilian Highlands , the Scandinavian Mountains and India's Western Ghats , are not rift shoulders. The formation of rift basins and strain localization reflects rift maturity. At the onset of rifting, the upper part of the lithosphere starts to extend on a series of initially unconnected normal faults , leading to

SECTION 20

#1732786669938
#937062